- This topic is empty.
-
Posts
-
There were no surprising deductions after the swap, which was good to see.
The allowance step was the only part I paused over. After checking it, Rango Bridge completed the route without issues.
The supported coin page was helpful when I was checking an unfamiliar asset. I confirmed the ticker before making the deposit.
My balance has not arrived yet, although the withdrawal says pending. I’m keeping the transaction details in case support asks for them.
The wallet connection section in the Rango bridge guide saved me a lot of guesswork. I now double-check both chains before confirming.
I started with a small withdrawal so I could verify the destination address. Omnichain was easy to use after I reviewed the fee, matched the network, and confirmed the transfer.
Fermi Swap worked as expected for my latest test, although I waited a little for final confirmation. The balance appeared once the transaction settled.
The Bungee bungee bridge aggregator is not perfect, especially when liquidity changes; I compare the quote again.
My wallet did not show the Arbitrum tokens immediately. Bungee still marked the transfer as successful, so I checked again before retrying.
I checked the BlackHoleSwap contract address before swapping and matched it with the details I had saved. That extra check felt sensible.
I let the network finish processing instead of worrying about the pending status, and the Chainflip deposit completed normally.
The documentation made Chainflip api feel less intimidating, especially once I understood the parameters.
The wallet showed a slightly different gas figure than the Mantle Bridge preview. The difference was minor, and I checked both before signing.
